The detail behind your configuration.
Find product specifications, understand the system interfaces and request the documents needed for your project.
Browse product specifications ↗
SENSING · CONNECTIVITY · INTEGRATIONReviewed engineering guides
Cylinder and actuator position feedback underwater
Separate end-of-stroke indication from proportional travel measurement and define the subsea signal path.
Read guide ↗guide · Rev 01Interpreting pressure, depth and immersion requirements
Distinguish operating conditions, pressure-test conditions and immersion claims when specifying a subsea assembly.
Read guide ↗guide · Rev 01Magnetic target selection for subsea proximity switches
Specify the target and installed approach geometry alongside the switch to make position feedback repeatable.
Read guide ↗guide · Rev 01Mechanical limit or proximity switch for submerged equipment?
Compare direct mechanical actuation and magnetic non-contact position indication around your mechanism.
Read guide ↗application · Rev 01Position feedback for locks, dams and flood-control gates
Specify submerged gate position sensing around real travel, mounting tolerances and maintenance access.
Read guide ↗application · Rev 01Position feedback for subsea valves
Define open and closed indication at the valve mechanism, with cable routing and accessible subsea connections.
Read guide ↗application · Rev 01Position indication for submerged lifts and platforms
Define travel and latch indications with protected cable routes and a clear control-system role.
Read guide ↗application · Rev 01Position monitoring in water and wastewater equipment
Define sensing and cabling requirements for submerged gates, valves and moving treatment equipment.
Read guide ↗guide · Rev 01Selecting an underwater position switch
Choose a sensing principle around the movement, target and electrical interface, then specify the complete subsea connection.
Read guide ↗guide · Rev 01Selecting underwater connector mating conditions
Specify where and how the connector will be mated, alongside the electrical and mechanical interface.
Read guide ↗guide · Rev 01Specifying a Nano subsea sensor-to-cable interface
Define the compact subsea connection, wiring and cable route as part of the sensor assembly.
Read guide ↗guide · Rev 01Specifying a subsea switch and cable assembly
Build one specification for the sensing device, underwater connector, cable and control-system termination.
Read guide ↗Find a useful starting point.
Product ratings, drawings and test requirements are confirmed for the selected configuration.
Product specifications
Find part numbers, variants and available specifications across the catalogue.
Browse products ↗RESOURCE / 02System architecture
Follow the interfaces from topside controls to subsea valve feedback.
Explore the system ↗RESOURCE / 03Assembly requirements
Capture connector, cable and operating requirements in a structured engineering brief.
Build your brief ↗RESOURCE / 04Drawings & documents
Request approved dimensional drawings, pin allocations and datasheets for your selected product.
Request documentation ↗RESOURCE / 05Application guidance
Review sensing and connection considerations for your operating environment.
Explore applications ↗Existing subsea switch replacement guidance ↗
Replacing an existing connector or cable assembly?
Start with the reference you have. Review what can remain installed, what needs to change and the details required for a DepthLink proposal.